BEST PRIMERS FOR
ANY SURFACE
Primers are the anchors for the new paint system. They provide excellent adhesion
for the new paint system before it’s applied. Primers therefore need to have good
adhesion to provide a surface that subsequent coats of paints can easily adhere to.
ZINC PHOSPHATE
An anti-corrosive water-based primer for use on galvanised iron and steel. Available in Red Oxide and White.
- Tough and durable
- UV resistant
- Low odour
- Rust inhibitor
- Excellent adhesion
- Good spreading rate
- Available in Grey, Red and White
- 100% lead-free
- Drying Time: 1 Hour
- Recoating Time: 2 Hours
- Application: Brush, roller or airless spray
- Thinning: Not recommended
- Spreading Rate: 6 – 7m²/litre, depending on surface porosity
- Cleaning: Water
- Coats: 2
- Stir thoroughly with a flat paddle before use
New Surfaces
New Galvanised Iron:
Remove grease, oil and temporary protective coating with Top Paints’ Degreaser and an abrasive pad. Rinse with clean water until water break-free film is achieved. Allow to dry.
Weathered Galvanised Iron:
Mechanically, ex. abrasive blasting, shot blasting, sanding, etc., remove oxidation and loose rust. Use either Top Paints’ General Purpose Cleaner or Top Paints’ Degreaser and an abrasive pad to clean the surface thoroughly. Rinse with clean water until water break-free film is achieved and allow to dry. Paint must be applied the same day. Apply 2 coats of WATER-BASED ZINC PHOSPHATE PRIMER.
New and Rusted Metal:
Mechanically, ex. abrasive blasting, shot blasting, sanding, etc., remove oxidation and loose rust. Use either Top Paints’ General Purpose Cleaner or Top Paints’ Degreaser and an abrasive pad to clean the surface thoroughly. Rinse with clean water until water break-free film is achieved and allow to dry. Paint must be applied the same day. Apply 2 coats of WATER-BASED ZINC PHOSPHATE PRIMER.
Old surfaces
Surfaces previously painted, with rust:
Remove all paint in rusted areas back to bare metal. Treat as new work.
Packaging
1, 5 and 20 litres
Storage
Store away from direct sunlight, heat and severe cold. Keep container sealed and avoid moisture contact.
Caution
During Winter months painting should be restricted to between 09H00 and 15H00, in Summer painting can be done between 08H00 and 16H00. Exterior surfaces – Do not paint if rain is imminent.
For full Technical and Material Safety Data Sheets, please contact Top Paints (016) 362 1054 or send an enquiry to sales@toppaints.co.za