BEST PAINT FOR ANY
OUTDOOR PROJECT

A fresh paint job has the power to totally transform the look of your house in less time
and for less cash than any other remodelling project. REMEMBER- The key to a
good exterior paint job is proper preparation.

SUPER SHEEN

A high quality, fully washable velvet finish interior & exterior paint.

12 Years

  • Low odour
  • Satin finish
  • Washable and stain resistant
  • Superior scrub ability 
  • Available in white and a range of standard colours
  • Can be tinted in a variety of colours
  • 12 Year guarantee
  • Long term protection against weather conditions
  • UV resistant
  • Exceptional obliteration and coverage
  • Maintains a satin finish over time
  • Touch Dry: 30min – 1 Hour @ 23°C
  • Recoating Time: 4 Hours @ 23°C
  • Spreading Rate: 7 – 8m² / litre, depending on porosity of surface and application

New Surfaces

New cement plaster:
Ensure the surface is in good condition before paint is applied. Allow cement plaster to cure and dry for 28 days to avoid moisture entrapment or any paint failure. Remove plaster spatter and dust. Apply Top Paints’ Plaster Primer and allow 12 hours to dry. Apply two coats Top Paints’ SIGNATURE SERIES SHEEN.

New fibre-cement, bricks and composition boarding:
Remove dust and loose particles. Apply Top Paints’ Plaster Primer and allow 12 hours to dry. Apply two coats Top Paints’ SIGNATURE SERIES SHEEN.

Previously Painted Surfaces

Old paint in sound condition:
Clean surface and rinse thoroughly. Ensure that the old coating adheres to the substrate. Apply two coats of Top Paints’ SIGNATURE SERIES SHEEN.

Previously painted with solvent based product:
Apply Top Paints’ Universal Undercoat and allow recommended drying time. Apply two coats Top Paints’ SIGNATURE SERIES SHEEN

Powdery surface:
Sand down and remove dust. Apply Top Paints’ Bonding Liquid and allow recommended drying time. Apply Top Paints’ Plaster Primer and allow 12 hours to dry. Apply two coats Top Paints’ SIGNATURE SERIES SHEEN.

Fungal growth:
Remove fungal growth by using Top Paints’ Fungal Wash. Rinse thoroughly and allow to dry.

Previously painted surface in poor condition:
Strip and treat as new work.

Gypsum Plaster:
GYPSUM PLASTER IS NOT RECOMMENDED FOR EXTERIOR USE

Interior: DO NOT SAND GYPSUM PLASTER. Apply Top Paints’ Plaster Primer and allow 12 hours to dry. Apply two coats Top Paints’ SIGNATURE SERIES SHEEN. Refer to Top Paints’ Plaster Primer technical data sheet for further information

Filling:
Use suitable and approved filler

Packaging
1L, 5L and 20L (white, standard colours and tint bases)

Storage
Keep away from direct sunlight, heat and severe cold Keep container sealed and avoid contact with moisture

For full Technical and Material Safety Data Sheets, please contact Top Paints (016) 362 1054 or send an enquiry to sales@toppaints.co.za